Difference between revisions of "Category:HamsterProKit"
From cogniteam
(→Connecting the kit) |
|||
| Line 11: | Line 11: | ||
* Use the LLC cable (in the picture) to both monitor and charge the battery | * Use the LLC cable (in the picture) to both monitor and charge the battery | ||
| + | * Port 9 can be used to charge the Lipo Battery | ||
* Port 8 should connect the the Lipo battery balancer (JST connector) | * Port 8 should connect the the Lipo battery balancer (JST connector) | ||
* Port 7 should connect to the LLC board | * Port 7 should connect to the LLC board | ||
* Connect the Up Squared board to the LLC as shown in the picture | * Connect the Up Squared board to the LLC as shown in the picture | ||
| + | * TX/RX should be connected to GPIO ports | ||
| + | * Power should be connected through DC connector | ||
Revision as of 07:05, 10 October 2019
AAEON Pro Kit support page
Kit prerequisite (not included in the kit)
- Lipo battery with T connector 7.4V 2 cell.
- Battery charger
Connecting the kit
- Use the LLC cable (in the picture) to both monitor and charge the battery
* Port 9 can be used to charge the Lipo Battery * Port 8 should connect the the Lipo battery balancer (JST connector) * Port 7 should connect to the LLC board
- Connect the Up Squared board to the LLC as shown in the picture
* TX/RX should be connected to GPIO ports * Power should be connected through DC connector
Subcategories
This category has the following 4 subcategories, out of 4 total.
