Difference between revisions of "Category:HamsterProKit"
From cogniteam
Line 9: | Line 9: | ||
== Connecting the kit == | == Connecting the kit == | ||
− | |||
* Use the LLC cable (in the picture) to both monitor and charge the battery | * Use the LLC cable (in the picture) to both monitor and charge the battery | ||
* Port 9 can be used to charge the Lipo Battery | * Port 9 can be used to charge the Lipo Battery | ||
Line 18: | Line 17: | ||
* TX/RX should be connected to GPIO ports | * TX/RX should be connected to GPIO ports | ||
* Power should be connected through DC connector | * Power should be connected through DC connector | ||
+ | * Connect the MX2 wifi module | ||
+ | * Connect the two WIFI antennas using the SMT connector to the integrated chip | ||
+ | * Connect the Movidius chip using the PCI connector | ||
+ | * Connect the D435i camera to a USB3 Port using the cable | ||
+ | |||
+ | |||
+ | == ROS Workspace == | ||
+ | * 2 ROS workspaces are available on the home directory for ROS1/ROS2 |
Revision as of 07:13, 10 October 2019
Contents
AAEON Pro Kit support page
Kit prerequisite (not included in the kit)
- Lipo battery with T connector 7.4V 2 cell.
- Battery charger
Connecting the kit
- Use the LLC cable (in the picture) to both monitor and charge the battery
* Port 9 can be used to charge the Lipo Battery * Port 8 should connect the the Lipo battery balancer (JST connector) * Port 7 should connect to the LLC board * Red T connector (rightmost on the picture)
- Connect the Up Squared board to the LLC as shown in the picture
* TX/RX should be connected to GPIO ports * Power should be connected through DC connector
- Connect the MX2 wifi module
- Connect the two WIFI antennas using the SMT connector to the integrated chip
- Connect the Movidius chip using the PCI connector
- Connect the D435i camera to a USB3 Port using the cable
ROS Workspace
- 2 ROS workspaces are available on the home directory for ROS1/ROS2
Subcategories
This category has the following 4 subcategories, out of 4 total.