Difference between revisions of "Category:HamsterProKit"

Revision as of 19:15, 4 December 2019

AAEON Pro Kit support page

Kit prerequisite (not included in the kit)

• Lipo battery with T connector 7.4V 2 cell.
• Battery charger

Connecting the kit

• Use the LLC cable (in the picture) to both monitor and charge the battery

 * Port 9 can be used to charge the Lipo Battery
 * Port 8 should connect the the Lipo battery balancer (JST connector)
 * Port 7 should connect to the LLC board 
 * Red T connector (rightmost on the picture)

• Connect the Up Squared board to the LLC as shown in the picture

 * TX/RX should be connected to GPIO ports
 * Power should be connected through DC connector

• Connect the MX2 wifi module
• Connect the two WIFI antennas using the SMT connector to the integrated chip
• Connect the Movidius chip using the PCI connector
• Connect the D435i camera to a USB3 Port using the cable

Quick start

1. Burn your image to AAEON board:

TODO LINK TO IMAGE

2. Connect to network via wifi/ethernet/HDMI. After image burning wifi will be avaliable: SSID: hamster_ap_2 WPA_PASS: hamsterHAMSTER

3. Bob's your uncle!

ROS1 examples

For launch SLAM example:

roslaunch hamster_launch prokit_slam_2d.launch

For launch wandering example:

roslaunch hamster_launch prokit_wandering.launch

For launch detection example:

roslaunch hamster_launch prokit_detection.launch

To see picture with detection use standart ros plugin: rqt_image_view