Category:HamsterProKit

AAEON Pro Kit support page

Kit prerequisite (not included in the kit)

• Lipo battery with T connector 7.4V 2 cell.
• Battery charger

1. Connecting all parts within the kit

• Use the LLC cable (in the picture) to both monitor and charge the battery

 * Port 9 can be used to charge the Lipo Battery
 * Port 8 should connect the the Lipo battery balancer (JST connector)
 * Port 7 should connect to the LLC board 
 * Red T connector (rightmost on the picture)

• Connect the Up Squared board to the LLC as shown in the picture

 * TX/RX should be connected to GPIO ports
 * Power should be connected through DC connector

• Connect the MX2 wifi module
• Connect the two WIFI antennas using the SMT connector to the integrated chip
• Connect the Movidius chip using the PCI connector
• Connect the D435i camera to a USB3 Port using the cable

2. Download the image and burn the image into your robot

Download image:

https://cloud.cogni.io/index.php/s/wEBt55X5qKoV5WN

Burn your image:

Instructions

3. Choose which way you want to configure the robot

First you need to access your robot with burned image via HDMI and configure wifi/ethernet settings.

Configure your wifi:

https://wiki.cogni.io/Category:HamsterProKit/WifiSetup

or use Ethernet connection:

https://wiki.cogni.io/Category:HamsterProKit/EthernetSetup

ROS1/2 environment

ROS1 - melodic provided

ROS2 - dashing provided

All relative sources are available in .bashrc file, just comment/uncomment required command and executesource .bashrc from terminal

ros melodic workspace - hamster_ws

ros dashing workpace - hamster2_ws

see examples below page